Recognize a millimeter and inch mismatch
One inch equals exactly 25.4 mm. If a 100 mm edge is read as 100 inches, it will measure 2,540 mm. If a 2-inch edge is read as 2 mm, it will measure 2 mm when the expected length is 50.8 mm.
Compare the measured and expected lengths in the same unit. Check a second edge. If both differ by the same 25.4 ratio, check the import units. If only one object differs, inspect its block or the snapped endpoints before scaling the whole drawing.
Measure two known edges in the DXF editor
Download the practice DXF above and open it in the editor. Click the command line, enter each command or coordinate below, and press Enter after each line. Skip the blank line. The first DIST reports 5,000 drawing units across the top outer wall and the second reports 3,500 along the left outer wall. The practice file specifies millimeters.
For your own file, run DIST between two known points in model space. Snap to the geometry’s endpoints and compare the result with the source dimensions. Zoom changes how large the drawing looks on screen.
DIST
0,3500
5000,3500
DIST
0,0
0,3500
Check the unit before changing geometry
In an ASCII DXF, look for $INSUNITS in the HEADER section. Typical values are 1 for inches, 4 for millimeters, and 0 for unspecified. Treat it as a clue. Importers differ, and the tag can be missing or inconsistent with the source drawing.
Confirm the author’s units and re-import with those source units. If needed, ask for a new export with units specified. Changing a display format or a unit label alone does not rescale existing geometry.
Calculate the factor and verify the saved copy
If you have confirmed that the coordinates must change, work on a separate copy. With both lengths expressed in the target unit, divide expected length by measured length. For an edge that should be 100 mm but measures 2,540 mm, the factor is 100 ÷ 2,540, or 1 ÷ 25.4. Use a drawing-unit conversion or a scale operation in the CAD application that will receive the file.
Reopen the saved copy in the destination application. Measure both reference edges again and check dimensions, blocks, and labels. If the measured lengths are right and only the printed output is wrong, check the layout and plot scale.